Filter
Top Products
26
Changing Pre-Set Options
Option Adjustment Mode
After using your Ecosmart you may want to fine tune some of the options to suit your wash
needs.
You can change the following pre-set options:
the default rinse option
the amount of water used in the Shower Rinse
the number of beeps at the end of the cycle
the Out of Balance recovery routine
the fill level selected by auto water level
the controlled cold
To make these changes it is necessary to enter the “Option Adjustment Mode”.
To enter Option Adjustment Mode
1.
Plug the machine in, but do not press POWER.
Press START / PAUSE and hold down, then press POWER.
2.
You will hear three quick beeps and the machine will
show an unusual pattern of lights. In this mode the
lights are used to indicate the different options available.
The diagram on page 27 shows how the lights relate
to the options you can change.
Pages 28–29 explain the different options in more detail.
3.
Use the buttons on the panel to make your changes to
the pre-set options.
4.
Press POWER to return to normal mode.
5.
Your Ecosmart will automatically remember
your changes.
6.
To make further changes, repeat the above steps.