Filter
Top Products
10
Selecting a programme and operating your machine
Changing the programme after the programme has started
You can use this feature after your machine has started to dry your clothes under higher or
lower temperatures.
For example:
Press and hold the
START/PAUSE/CANCEL button for about 3 seconds to cancel the programme in
order to select
EXTRA DRY programme instead of READY TO IRON programme.
Select the
EXTRA DRY programme by rotating the programme knob.
Press
START/PAUSE/CANCEL button to start the programme.
The programme which is selected first will go on even if the programme selection button is
moved and another programme mode is selected while the machine is operating. You must
cancel the ongoing programme in order to change the drying programme. (See, ‘Ending the
programme through cancelling’ page 11).
Adding/removing laundry in standby mode
If you want to add or remove laundry into/from your machine after the drying programme has
started, put the machine into pause mode by pressing the
START/PAUSE/CANCEL button. The
drying process will stop. Open the door at pause position and close it again after adding or
taking out laundry. Press
START/PAUSE/CANCEL button to start the programme.
Any laundry added after the drying process was started may cause the already dried clothes in
the machine to intermingle with wet clothes and the result will be wet laundry after the drying
process is over.
It is not recommended to add laundry after the programme is started as it will increase the
programme time and energy consumption.
Childproof lock
There is a childproof lock to prevent any programme interruption due to the pressing of keys
while the programme is on. The loading door and all keys except the
ON/OFF key on the panel are
deactivated when the childproof lock is active.
In order to activate the childproof lock, press on the
START/PAUSE/CANCEL and BUZZER CANCEL
buttons simultaneously for 3 seconds.
To start a new programme after the programme is over or to interrupt the
programme, the childproof lock should be deactivated.
To deactivate the childproof lock, press the same buttons for 3 seconds.
Two beeps will sound when the childproof lock is activated. A single beep
will sound when the lock is deactivated.
Fig.6 Using the
childproof lock