![](http://pdfasset.owneriq.net/d/03/d03f2135-22a4-4e04-9528-cf3a761ad165/d03f2135-22a4-4e04-9528-cf3a761ad165-bg3.png)
GETTING TO KNOW YOUR GARMENT STEAMER/IRON
TROUBLESHOOTING
PROBLEM POSSIBLE REASONS & SOLUTIONS
Garment Steamer/Iron
does not heat
Pilot light
goes On and Off
Some odor or small
particles come out of
steam vents of new
iron
Garment Steamer/Iron
does not steam
Water droplets coming
from steam vents
• Make sure that the plug is securely in the socket.
• Temperature setting too low.
Turn to higher setting.
• This is normal.
The light goes On and Off as the thermostat is
switching the heating element On and Off to
maintain the selected temperature.
• This is normal.
Follow instructions for first use and allow iron to steam
through 2-3 fillings & press the steam trigger
occasionally to eliminate small white particles.
• Water tank may be empty or water level is very low.
Add water.
• Make sure that the temperature control dial is correctly
set. For maximum steam, (setting ‘Max’ on steam
control), temperature control dial should be set on ‘•••’.
• Make sure the iron has reached the selected
temperature by confirming that the pilot light has gone
"Off". For more steam, turn temperature dial to
higher setting, e.g. ‘•••’.
• If temperature setting is correct and there is no steam,
gently
tap the soleplate on the ironing board a few
times. Move the temperature control dial from ‘MIN’ to
‘Max’ a few times.
• Iron may not be hot enough. Set temperature control
dial to the ‘Max’ position. Always allow iron sufficient
time to heat up (pilot light goes off).
• Overuse of steam trigger. Allow more time between
each burst.
• Iron may have been overfilled. Turn iron off,empty
water and follow instructions for filling.
• Steam performance may be low if iron requires
seasoning. To season, use regular tap water for 1or 2
tanks until steam performance improves.
1. Temperature Control Dial
2. Red Pilot Light
3. Steam Trigger
4. Water Inlet Cover
5. Red Lint Brush
6. Bristle Garment Brush
7. Locking Tab
8. Swivel Handle
9. Water Measuring Beaker
10. Dual Voltage Selector
(not shown)
Technical Specifications
Voltage: 115/120 V., 60Hz.
230/240 V., 50 Hz.
Power: 800 Watts/870 Watts
2
9