Filter
Top Products
OPERATING INSTRUCTIONS GETTING TO KNOW YOUR STEAM GENERATOR
REFILLING THE STEAM
GENERATOR
PRESSING TIPS (cont.)
Instructions for specific iron
temperature settings should be
treated as guidelines only. We
recommend that you test each type
of fabric on an inside seam before
proceeding to iron the garment. The
steam generator iron can produce
humid steam at relatively low
temperature settings where regular
household irons would release
water. At the same time, the very dry
steam produced at the high iron
temperature setting “•••” can be used
on some fabrics where normally the
use of steam is prohibited.
PRESSING DIFFICULT FIBERS
(i.e. 100% COTTON)
Your Steam Generator Iron features
steam holes placed in the front of the
iron soleplate. Correct ironing
procedure involves steaming the
fabric with the front end of the iron
followed by pressing and drying with
heat from the rear of the iron. For
best results, garments should be dry
after pressing to avoid re-wrinkling
due to lingering dampness.
Therefore, we recommend that you
use the steam as required, but not
continually.
While your Steam Generator Iron
offers high quality type steam, some
fabrics may require additional
moisture for best results. You may
want to press cotton shirts while still
damp or spray with water prior to
ironing.
WARNING! Never direct the
steam from the iron at yourself
or another person. Special care
must be taken when the iron is
used in a vertical position. The
steam is very hot and can
cause burns.
1. Press the steam generator On/Off
button to the “OFF” position.
2. Release all the remaining steam in
the steam generator by pressing the
steam button until no more steam is
coming out from the iron.
3. Unplug the appliance from the wall
outlet. Allow it to cool for a minimum
of 5 minutes.
4. To unscrew the boiler filler cap, push
down and turn counter clockwise
slowly. If any steam continues to
escape, STOP
and release the
steam through the iron as in the
steps above.
5. Using a measuring cup, fill the water
tank with 26 US fl. oz.
6. Replace the boiler filler cap turning
clockwise until you get friction. DO
NOT OVERTIGHTEN OR GASKET
WILL BE FLATTENED.
PRESSING TIPS
Dry Steam vs Humid Steam
In a steam generator iron the steam
is produced in the generator and not
in the iron as with regular household
irons. The temperature of the iron
determines the type of steam – dry
or humid. At high temperatures, the
iron delivers very dry steam. Lower
temperature settings offer humid
steam.
For best pressing results, you have
the flexibility to select the type of
steam and not only the iron
temperature. A balance should be
maintained between the humidity
(low iron temperature) required to
loosen fibers and the need for heat
(higher iron temperatures) to
flatten/shape and dry the fibers.
1. Boiler Filler Cap
2. Steam Ready Light (green)
3. On/Off Button (red)
4. Steam Generator Base
5. Iron Rest Plate
6. Power Cord
7. Steam Hose
8. Steam Button
9. Temperature Ready Light
10. Temperature Control Dial
11. Stainless Steel Soleplate
Technical Specifications
Voltage: 120V., 60Hz.
Power: 1500 Watts
Water Capacity: 26 US fl. Oz.
Working Pressure: 2.9 bar
4
7