Filter
Top Products
12
WATER SPRAY
Fig. 10
• Use the spray button to add moisture to stubborn wrinkles.
• First make sure that there is water in the tank.
• Press the spray button (3) slowly to get a jet spray. (Fig. 10)
• Press the spray button strongly and quickly to get a mist.
• Please note: If spray does not come out when you press the spray button,
cover the spray opening with your finger and press a few times.
IRONING WITH STEAM
Fig. 11
• As indicated on the temperature control dial (1) and the fabric table, steam
ironing is only possible at the higher ironing temperature settings: •• for
moderate or ••• for maximum steam.
• With conventional steam irons, water may leak from the soleplate if too low a
temperature has been selected. However, your new steam iron has an “Anti-
Drip” feature which will automatically stop the iron from steaming at too low a
temperature. When this happens, you will hear a “Click”. Set the temperature
control dial (1) to the advised position. Steaming will restart when the
appropriate temperature has been reached.
• Ensure that there is enough water in the water reservoir.
• Place the iron on its stand (12) and set the temperature control dial (1) to the
required position within the “steam area” (•• for moderate or ••• for maximum
steam). (Fig. 11)
• After the thermostat light (7) has gone out and has come on again, you may
start ironing.
• Slide the variable steam control (2) to the required position. (Fig. 12)
Fig. 12