Filter
Top Products
OPERATING INSTRUCTIONS (cont.)
FEATURES OF SHARK CORDED/CORDLESS IRON
1. BLAST OF STEAM BUTTON
Pressing this Button provides a
powerful blast of steam without
dripping water.
4. TEMPERATURE DIAL
Turn dial to select
temperature. Main
temperature settings are
indicated by the 1, 2 and 3
dots. (See “Ironing Chart.”)
2. ATOMIZER SPRAY
BUTTON
Pressing this Button provides a
defined jet of spray which gently
moistens fabric.
5. WATER FILLING INLET
The cover prevents dust and
foreign matter from entering
the water tank. It also stops
any water from spilling during
ironing.
3. VARIABLE STEAM
CONTROL
For selecting dry ironing, slide lever
down. For steam ironing, gradually
slide lever up to increase the
amount of steam.
4
1
2
3
SELECTING IRON
TEMPERATURES
Always read garment labels and follow
the manufacturer’s ironing instructions.
Refer to the “Ironing Chart” on page 10
for temperature recommendations:
• Use low settings for synthetics.
•• Use moderate settings for wool,
silks, and blends.
••• Use high settings for cottons and
linens.
IRONING HINTS
WARNING! To prevent fire, do not
leave iron unattended while
connected.
• Sort articles to be ironed according
to the type of fabric. This will reduce
the need to adjust the temperature
for different types of garments.
• If you are not sure of the fiber
content of a garment, test a small
area such as a seam or inside hem
section before ironing a visible area.
Start with a low temperature setting
and gradually increase to find the
best setting.
• When reducing the temperature to
iron sensitive fabrics, allow
approximately 2 minutes for the iron
to cool to the new temperature
setting.
• Fabrics such as velour, wool, linen
and silk are best ironed with an
ironing cloth to prevent shine marks.
NOTE: Before starting to iron delicate
fabrics, it is best to first test the
temperature of the iron on a hem or an
inside seam.
Temperature Control Dial
Variable Steam Control
Figure 6
Figure 7
Red
Light
6. AUTO SHUT-OFF
The electronic auto-off
switches the iron off if it has
been standing unmoved for
approximately 8 minutes. A
red light will flash when the
iron switches itself off. To
switch the iron back on
again,shake the iron.
7