Filter
Top Products
OPERATING INSTRUCTIONS cont. OPERATING INSTRUCTIONS cont.
IRONING WITH STEAM
BURST OF STEAM & VERTICAL STEAM
Please note: Before using the iron for the first time, it is important to
purge the inside of the iron by allowing it to steam freely for
a minute. This allows the removal of any impurities left by
the manufacturing process.
WARNING! DO NOT aim iron at face, towards yourself, or anyone else while
using or adjusting steam. Burns or serious injury may occur.
The burst-of-steam button is useful when ironing denim, cotton and linens. It
provides extra, sudden blasts of steam which aid in removing stubborn
wrinkles.
The burst-of-steam & vertical steam feature can be used with Dry or Steam
ironing as desired.
1. Make sure the water tank is filled with water.
2. Follow filling instructions on page 3.
3. Plug the power cord into the electrical outlet.
4. Set the temperature control dial within the steam area, i.e. “• • • ”.
(See page 4 for setting the temperature.)
5. The thermostat light will go “On”.
6. When the correct temperature has been reached, the thermostat
light will go “Off”.
7. Now turn the Spray/Burst of Steam button to the Steam setting
and set the Steam Control Knob to the highest steam setting.
8. When the thermostat light has gone off, keep the iron in the vertical position
and press the Steam/Spray button to produce a strong steam jet. See
illustration below. To prevent water leaking from the soleplate, do not keep
the burst of steam button depressed fore more than 5 seconds.
WARNING! DO NOT aim iron at face, towards yourself, or anyone else while
using or adjusting steam. Burns or serious injury may occur.
1. Make sure that the iron is unplugged from the power source.
2. Set the steam control knob to no steam.
3. Fill the iron with water following the instructions for filling on page 3.
4. Plug the power cord into the electrical outlet.
5. Set the temperature control dial within the steam area, I.e. “• • • ”.
(See page 4 for setting the temperature.)
6. The thermostat light will go “On”.
7. When the correct temperature has been reached, the thermostat
light will go “Off”.
8. Now Turn the Spray/Burst of Steam button to the Steam setting
and set the Steam Control Knob to “ON”.
See illustration below.
Burst of Steam Vertical Steam
Please note: For maximum steam, the temperature control dial should
be set at “• • • “ and the Steam Control set to the steam setting.
IMPORTANT: If the iron has not been set to the correct temperature setting
for steam, water drops may leak from the soleplate.
5 6