Filter
Top Products
Inspecting WHEN TO REMOVE SHIPPING BOLTS!
WARNING!!! TIPPING THE MACHINE TO POSITION IT FOR USE
MUST BE DONE WITH THE SHIPPING BOLTS STILL IN THE
MACHINE!
TIPPING THE MACHINE WITHOUT SHIPPING BOLTS, CAN CAUSE
THE INNER DRUM TO IMPACT OTHER INTERNAL PARTS, THUS
DAMAGING THEM. POSITION THE MACHINE AS CLOSE AS
POSSIBLE TO IT’S FINAL POSITION AND THEN REMOVE SHIPPING
BOLTS.
Page 2
√ INSPECT CONTENTS
[ ] Owners Manual
Brass Pressure Regulators
[ ] (Must be installed on hot and
cold water inlet. Failure to do
so can damage the internal
components and cause water
damage for which the
installer/owner will be re-
sponsible!)
[ ] Warranty Registration Card
[ ] Majestic Literature
[ ] Hoses have washers in
both ends.
Brass Pressure
Regulators
installed on back of
appliance.
REMOVING THE FOAM DRUM SUPPORT
REPLACING THE METAL BOTTOM PAN.
WARNING!!! IN ORDER TO REMOVE THE
FOAM DRUM SUPPORT AND REPLACE THE
METAL BOTTOM PAN, THE BOTTOM OF THE
MACHINE MUST BE ACCESSED. SHIPPING
BOLTS MUST REMAIN IN THE APPLIANCE
WHILE ACCOMPLISHING THIS STEP IN THE
PREPARATION PHASE OF THE INSTALLATION.
ATTENTION:
DO NOT TAKE
OUT SHIPPING
BOLTS UNTIL
MACHINE IS
POSITIONED
WITHIN A FEW
INCHES OF ITS
FINAL INSTALL-
TION POINT. TIP-
PING THE UNIT
OR MOVING IT
WITHOUT SHIP-
PING BOLTS
WILL VOID WAR-
RANTY.