Filter
Top Products
7
Combo Washer
-
Dryer Owner’s Manual
SAFETY
The model number of this product may be found on
the back of the unit; the serial number of the label
affixed to the back of the unit.
You should note the model and serial numbers of
this unit in the space provided. Retain this booklet
as a permanent record of your purchase to aid in
identification in the event of theft.
MODEL#
SERIAL#
INTRODUCTION
Your new appliance is carefully engineered product. Many times what appears to be a reason to call
service, the problem may require nothing more than a simple adjustment you can easily make in your
own home.
You will be charged for a service call while the appliance is in warranty if the problem is not
caused by defective product workmanship or materials covered by this warranty.
To avoid a charge for an unnecessary service call, and before calling a serviceman, please refer to
the troubleshooting section for situations that you can remedy. This section is included on pages 21 of
this Owner’s Manual.
Your Washer-Dryer is front loading, with an extra large door opening for easier access. It has 10
wash programs.
You will obviously want to obtain the best possible wash. By reading and following the instructions in
this booklet you will achieve excellent results.
Please, ensure that the instructions are followed. If you should need any further advice or assistance,
please, contact the dealer where your machine was purchased, or contact Customer Service at
service@equatorappliances.com
This appliance is an automatic washer-dryer with a capacity of up to:
- WASH 14 Lbs
- WASH & DRYING 9 Lbs dry weight of clothes
PRE-INSTALLATION
1. The unit must be installed on a strong level floor, and in protected, dry, and well-ventilated area
close to a power and water supply of sufficient capacity, and a sufficient outlet.
2. Installation on Carpet or Wood increases vibrations.
• Carpets – place on light carpet only.
• Wood – brace floor with screws and place additional sheets of plywood before installation.
3. This unit’s installation and grounding should be done in accordance with local codes by a qualified
installer. “Installation Instructions” are included in this manual for the Installer’s reference.
4. The unit should be plugged into a properly grounded three (3) prong electrical outlet of 110V/60Hz
with minimum 15 Amps, It should not be controlled by a wall switch or pull cord which might be turned
off accidentally.
CAUTION
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER
SERVICABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PROFESSIONALS.
RISK OF ELECTRIC SHOCK
DO NOT OPEN