Filter
Top Products
After removing the appliance from its packaging, check that it
is intact. If in doubt, contact Equator immediately. The inside
of the machine is supported, for transportation, by four
shipping bolts on the back panel.
Before using the washer-dryer, remove the external
shipping bolts, remove the spacers together with the rubber
tubes attached to them (save all the parts) and use the plastic
blanking plugs provided to fill in the holes. Use the wrench
provided to remove the external bolts.
Attach the two rubber hoses provided to the red (hot) and
white (cold) water inlets
on the back (top right) or the appliance.
Connect the other ends to the appropriate built-in water supplies or a
Y-adapter / Faucet Adapter combination to a single source (like a kitchen
faucet.). Using the “U”-Connector provided, place the drain hose into the
drain pipe (or the sink.) See Plumbing on Pg. 7 for more details.
Leveling
The washer-dryer must be levelled appropriately in order to
guarantee its correct functioning. To level the appliance, the front
feet must be adjusted; the angle of inclination, measured according
to the worktop, must not exceed 2°.
WARNING !
Excessive Weight Hazard
Use two or more people to move
and install your appliance.
Failure to do so can result in
back or other injury
The front feet are self-locking & adjustable
Instructions for installation and use
6
When the new washer-dryer arrives
Installation
Whether new or just transported to a new house, installation is extremely important
for the correct functioning of your washer-dryer.
For your own protection, and to prevent accidents, injury and
fire, please read the following carefully:
1. Destroy the carton and plastic bags, after the washer-dryer
has been unpacked.
2. Children should never be left alone or unattended in the
area where appliances are located.
3. Washer installation and grounding must be done in
accordance with local codes by a qualified installer. Installation
instructions are packed in new washer to the installer’s
reference.
4. ONLY the Equator Low Sudsing detergent is recommended
for this appliance. To order your box of Equator detergent call
1-800-935-1955.
5. The washer must be plugged into a properly grounded 3-
prong electrical outlet. For your safety, the third or round
grounding prong must never be removed.
DO NOT USE AN EXTENSION CORD.
6. Repair or replacement of a part should be made only by a
qualified service technician to prevent personal injury or damage
to the machine. For a list of authorized repair service agents,
call Equator Service at 1-800-776-3538.
7. Disconnect power to the washer at the circuit breaker or
fuse box, or unplug the machine in an emergency when
servicing is required. Have the installer show you and label the
proper switch or fuse at the electrical disconnect box.
WARNING - The Appliance should be connected to an
Individual Branch Circuit with N.. 14 AWG Wire and
Protected by 15 A Fuse.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of malfunction,
or breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current. This
appliance is equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check a qualified
electrician if you are in doubt as to whether the appliance is
properly grounded.
Do not modify the plug provided with the appliance. If it will not
fit the outlet, have a proper outlet installed by a qualified
electrician.
Retain the shipping bolts, spacers and washers.
Should you move residence then these should be
replaced to support the inside of the machine to
prevent damage when transporting the machine.
Warning !
The company denies all liability if and when these
instructions are not respected. Plastic bags,
expanded styrofoam, nails and other packaging
parts are not children’s toys, are potentially
dangerous and should be disposed off properly.
WARNING ! Electrical Requirements
Electrical Shock Hazard (death, fire or electrical shock):
1) Plug into a grounded 3 prong outlet.
2) Do not remove ground prong.
3) Do not use an adapter or an extension cord.