18 Washer Owner’s Manual
UNDERSTANDING FABRIC CARE LABELS
The symbols on labels of your garments will help you in choosing the suitable wash
program, the right temperature, wash cycles, and ironing methods. Don’t forget to give a
glance to these useful indications!
WINTERIZING YOUR WASHER
To winterize your washer please, follow the instructions below to avoid damage to
your unit due to freezing:
1. With the unit off, remove wash filter. This will allow the water remaining in the pump and
drain hose to be evacuated. Replace filter.
2. Close the inlet shut-off valves (provided by installer) and disconnect the inlet
hoses. There should be no water in the hoses where they attach at the back of the
machine.
IF ANTIFREEZE IS BEING USED IN THE SYSTEM FOLLOW THESE INSTRUCTIONS:
(Not necessary if the above drain procedure is followed)
1. When putting antifreeze into the water system of your coach, set the washer to a warm/warm
fill setting and allow water to flow into unit until antifreeze is detected.
2. Advance the knob timer on “Reset”, turn on “Rinse” position and allow water to flow for 10
seconds.
3. Advance the knob timer on “Reset” and then turn again on “Spin” to remove the majority of
the water from the unit.
4. With the unit off, remove wash filter from unit. This will allow the water remaining in the pump and
drain hose to be evacuated. Replace filter.
5. If you elect you may close the inlet shut-off valves (provided by installer) and disconnect the
inlet hoses.
6. Any water remaining in the unit should contain antifreeze and be protected from freezing.
Note: When placing unit into service allow unit to operate for one complete cycle before doing
laundry to ensure all antifreeze has been purged from the unit.
If you have any further questions pertaining to this matter please contact Technical Support Toll free
at (tech@appliancedesk.com