Filter
Top Products
9 Washer Owner’s Manual
INSTALLATION
UNPACKING, LEVELING, & POSITIONING
Remove the packing and check that the washer dryer is undamaged. If you have any doubt,
do not use the washer dryer and call Equator Customer Service. Keep all packing parts
(plastic bag, foam rubber, screws, etc.) out of the reach of children since they could be
dangerous.
Important: The inside of the washer dryer consists of a free floating drum that is affixed with
shipping bolts at the back of the cabinet (Fig.1) during transport. Before starting the machine,
remember to remove the shipping bolts. To prevent water spray from entering the machine,
remember to close the holes left open by the bolts with the plastic caps provided in the
packet containing the Owner’s Manual.
It is important for the machine to be perfectly level. For this reason, the machine is fitted with
adjustable feet used for leveling the machine before use (Fig.2).
In the case of flooring with carpeting, remember to check that there is sufficient
ventilation around the machine.
(Fig.1) (Fig.2)
ELECTRICAL CONNECTION
Connect the plug to a power outlet – 110V/60Hz with minimum 15 Amps. Make sure that the
voltage and frequency available correspond with those stated on the serial number plate
located on the machine. Do not use adaptors or extension cords since they could result in
overheating and burn out.