Filter
Top Products
Operating Instructions
31
The door cannot be
opened when the
washing machine
is on.
START/PAUSE
and DOOR lights
come on.
Door is locked due to high
water level, or high tempera-
ture.
Wait until the programme has
ended, the DOOR light goes off
and the END light is lit.
If it is necessary to open the
door immediately,
Turn the programme selector
to OFF; then turn it to DRAIN.
Press the START/PAUSE but-
ton.
When the water has been
pumped out, the door can be
opened.
Power failure dur-
ing a wash pro-
gramme (all
indicator lights
are off).
The failure may be caused by
a blown house fuse or by a
mains supply fault into the
house.
(For safety reasons, the door
remains locked for around
2minutes.)
The programme continues
when power is restored.
If washing has to be taken out
during a power cut:
Turn the control knob to OFF.
Carry out emergency emptying
(see Section "Carry out emer-
gency emptying“).
After about 2 minutes,
the door can be opened by
pulling on the handle.
Remnants of deter-
gent are building
up in the detergent
drawer.
The water tap is not fully
opened.
Open the water tap fully.
The inlet hose filter in the in
coupling of the inlet hose at
the tap is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the machine.
Clean the filter.
The rinse water is
cloudy.
The cause is probably a deter-
gent with a high silicate con-
tent.
This has no negative effects on
rinse results; use a liquid de-
tergent if necessary.
When pressing
a programme op-
tion button,
the corresponding
indicator does not
light up.
The selected programme op-
tion cannot be combined with
the set programme.
Make another selection.
Problem Possible cause Remedy