Filter
Top Products
32
3 Sealing rings are either inserted in the plastic nuts of the threaded hose
fitting or are included as spare parts. Do not use any other sealing
rings.
Important! All threaded hose fit-
tings must only be tightened by
hand.
1.Connect the hose with the right-an-
gle connector to the machine.
Important! Do not position the inlet
hose vertically downwards. Position
it to the right or the left as shown in
the illustration.
2.Connect the hose with the straight
connector to a water tap with an R
¾ (inch) screw thread.
3.Slowly turn on the tap and check
that all connections are watertight.
Water Drainage
The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the plastic “U-Piece“ supplied. The standpipe
should have an internal diameter of approximately 38 mm (see dia-
gram) thus ensuring there is an air break between the drain hose and
standpipe.
Important! It is essential to lay the drainage hose without kinks.