Filter
Top Products
The upright standpipe should have a mini-
mum length of 30 cm (12”) from the bottom
of the elbow to the top of the pipe (see dia-
gram). Make sure that it is designed in such a
way that the end of the drain hose cannot be
covered with water.
If you intend the drain hose from the machine
to empty into a sink, make sure that the sink
is empty and the plug hole is not blocked. Use
the plastic “U -Piece” supplied.
Important
Before connecting up the machine to new
pipework or to pipework that has not been used
for some time, run off a reasonable amount of water to flush out any debris
that may have collected in the pipes.
In the interest of the environment
Washing machines and dish-
washers should be connected
to the FOUL drainage system,
the water will then be taken
to a sewage works for treat-
ment before being discharged
safely into a river.
It is essential that these appli-
ances are not connected to the
surface water drainage system
as this water is discharged
directly into a river or stream
and may cause pollution.
If you require any further
advice please contact your local
water authority.
52
Installation
SHOWER
BATH
SINK
TOILET
BIDET
WASHING
MACHINE
DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
TREATED
DISCHARGE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
Min. 30 cm.(12")
38 mm.(1/ ") diameter
standpipe
1
2
132994040.qxd 1/22/03 9:16 AM Pagina 52 (Nero/Process Black pellicola)