Filter
Top Products
c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B).
The hinges can be adjusted to compensate for possible uneven thick-
ness of the door.
To align the door perfectly it is necessary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a mag-
netic closure of the door. To enable a cor-
rect operation of this device, it is necessary
to screw the counter-magnet (6) (steel disk
+ rubber ring) into the inner side of the
door.
Its position must correspond to the magnet
(4) on the appliance (see picture D).
If the door has to be opened from
left to right, invert the position of
the plates (7), the magnet (4) and
the plate (5) (Fig. B and E). Mount
the countermagnet (6) and the
hinges (1) as previously described.
Attention!
When the appliance is installed the
power supply cable must be easily
accessible.
51
6
4
8
D
4
6
5
1
2
3
7
8
E
132984560.qxd 07/10/2005 19:07 Pagina 51