Filter
Top Products
Operating Instructions
23
Starting the washing programme
0 1. Check that the water tap is open.
2. Start the washing programme:
Press the START/PAUSE button
The washing programme is started or starts
at the end of the time delay set.
3
If the DOOR display flashes red when the START/PAUSE button is
pressed, the door is not properly closed.
– The display DOOR flashes red
– The error code E40 then flashes in the multi display
– And the MAIN WASH display flashes.
In this case, press the door firmly closed and again press the
START/PAUSE button.
If the delay timer has been set:
The start time delay set on the time delay counts down; the time
remaining until the programme starts is displayed in the multi-display
(in hours remaining, e.g. 5h). During this time you can add washing and
change or stop the delay timer.
• Load the washing: Press the START/PAUSE button. The door can be
opened. Then close the door and press the START/PAUSE button
again.
• Changing or stopping delay timer: Press the DELAY TIMER button re-
peatedly until the desired time is displayed. When the programme
duration is displayed (display in minutes e. g.126) the washing
programme starts without delay.