Filter
Top Products
Installation and connection instructions
48
Inlet Hose Connection
A pressure hose of 1.35m in length is supplied.
If a longer inflow hose is required, only a VDE-approved, complete set
of hoses with fitted hose screw connections is permissible, available
from AEG Service Force Centres.
– Hose sets in lengths of 2.2m, 3.5m, and 5m are available for washing
machines without Aqua-Control.
– Hose sets in lengths of 2.0m, 2.9m and 3.9m are available for wash-
ing machines with Aqua-Control.
Important! Never cut into pieces in order to extend the hoses!
3
Sealing rings are supplied either in the plastic
nuts of the hose screw connection or in the
enclosed pack. Do not use other seals!
0 1. Connect the hose with the angled connection to
the machine.
Important!
– Do not lay the inlet hose verti-
cally downwards, instead run it
to the right or left as shown in
the diagram.
– Tighten firmly to prevent
leakage but do not use
excessive force.
2. Connect the hose with the straight connection
to a water tap with a screw thread R 3/4 (inches)
Important! Only tighten the screw connection
by hand.
3. By slowly opening the water tap before putting
the washing machine into operation, check that
the connection is free of leaks.