Filter
Top Products
1
2
4
3
DRAINAGE FILTER
Clean the filter located at the base of the
appliance regularly :
1
2
3
5
4
7
6
WATER INLET FILTERS
To clean, proceed as follows :
OPERATING PROBLEMS
Numerous checks were carried out on your
appliance before it left the factory. Howev-
er, should you notice a malfunction, please
refer to the sections below before contact-
ing the after-sales service.
Problems Causes
The washing machine
doesn’t start or doesn’t
fill :
• the appliance isn’t plugged in correctly, the electrical installation isn’t
working,
• the lid of your appliance and the drum shutters aren’t closed firmly,
• the programme start command hasn’t been properly selected,
• there is a power failure,
• the water supply has been cut off,
• the water inlet tap is closed,
• the water inlet filters are dirty,
•
a red tab appears on the water inlet hose
1)
.
The appliance fills but
empties straight away :
• the drainage U-piece is fixed too low (see installation section).
The washing machine
doesn’t rinse or doesn’t
empty :
• the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly
distributed in the drum,
• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option
have been selected,
• the height of the drainage U-piece is unsuitable.
You have found water
around the washing ma-
chine :
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn’t attached correctly,
• the drainage filter hasn’t been put back in place,
• the water inlet hose is leaking.
8 electrolux