Electrolux EWG 12450 W Washer/Dryer User Manual


 
control panel electrolux 9
Duration of selected
programme/
After selecting a programme, the
duration is displayed in hours and
minutes (for example
2.05). The
duration is calculated automatically on
the basis of the maximum
recommended load for each type of
fabric. After the programme has
started, the time remaining is updated
every minute.
/Delayed start
The selected delay set by pressing the
relevant button appears on the display
for a few seconds, then the duration of
the previously selected programme is
displayed.
/Alarm codes
In the event of operating problems,
some alarm codes can be displayed,
for example
E20 (see chapter «What to
do if...»).
7.1
/Incorrect option selection
If an option which is not compatible
with the set wash programme is
selected, the message Err is displayed
for a few seconds and the integrated
red light of button
8 starts blinking.
/End of programme
When the programme has finished
three blinking zeros
0.00 are displayed,
the pilot light 9 and the pilot light of
button 8 go out and the door can be
opened.
Washing phase icons
By selecting the wash programme, the
washing programme phase icons
corresponding to the various phases
making up the programme are shown
in the bottom of the display.
After the machine has started, only the
running icon stays on. When the
programme has finished, the flashing
zero (
0.00) is displayed.
7.2
2.05
7.1
7.27.3
7.4
7.5
Display (7)
132964710.qxd 19/07/2008 12.21 Page 9