Filter
Top Products
3. Set the hose correctly by loosening
the ring nut.
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
The inlet hose is provided with a water
stop device, which protects against
damage caused by water leaks in the
hose which could develop due to natural
ageing of the hose. This fault is shown
by a red sector in the window “A”.
Should this occur, turn the water tap off
and refer to your Service Centre to
replace the hose.
A
P0352
P0351
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine. In this
case, make sure the end cannot come
unhooked when the machine is
emptying. This could be done by tying it
to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a
height of not less than 60 cm and not
more than 90 cm. The end of the drain
hose must always be ventilated, i.e.
the inside diameter of the drain pipe
must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Centre.
P1118
P0022
installation electrolux 41
132978151 EN.qxd 04/12/2006 16:06 Pagina 41