Filter
Top Products
48 electrolux use
Alarm codes
In the event of operating problems,
some alarm codes can be displayed, for
example
E20
(see paragraph “Something
not working”).
End of programme
When the programme has finished a
flashing zero is displayed.
Heating phase
During the washing cycle the display
shows a temperature icon to indicate
that the appliance has started the
heating phase of the water in the tub.
Select the Start/Pause
To start the selected programme, press
the “Start/Pause” button; the green
pilot light stops flashing.
The “wash” and “door” lights
are on to indicate that the appliance
starts operating and the door is locked.
To interrupt a programme which is
running, depress the “Start/Pause”
button: the green pilot light starts to
flash.
To restart the programme from the point
at which it was interrupted, press the
“Start/Pause” button again.
If you have chosen a delayed start, the
machine will begin the countdown.
If an incorrect option is selected, an
integrated red pilot light of the “Start/
Pause” button flashes for 3 times.
Select the Delay start
Before you start the programme, if
you wish to delay the start, press the
Delay Start button repeatedly, to select
the desired delay. The selected delay
time value (up to 20 hours) will appear
on the display for about 3 seconds,
then the duration of the programme will
appear again.
You must select this option after you
have set the programme and before you
press the Start/Pause button.
You can cancel the delay time at any
moment, before you press the
Start/Pause button.
35.293.042…EWF10260-EWF12260.qxd 14/9/06 13:20 Página 48