Filter
Top Products
26 electrolux installation
Note that to avoid condensation
problems, it is essential that the dryer
be fitted with the flexible hose to carry
its “exhaust” at least beyond the
kitchen units; preferable outside the
kitchen.
In order to prevent the appliance from
overheating, it is important that the
steam exhaust is unobstructed.
Therefore, in case of a permanent hose
fitted to an exterior wall or ceiling, it
must be ensured an exhaust capacity
of at least 150 m3/h.
If the dryer is fitted next to kitchen
units, make sure that the vent hose is
not squashed. If the hose is partially
squashed, drying efficiency will be
reduced, resulting in longer drying
times and higher energy consumption.
If the hose is completely squashed, the
safety cut-outs with which the machine
is fitted may operate.
When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the
appliance.
Stacking kit
A special stacking kit is available through
your dealer, to enable the mounting of
the dryer on top of a front loading
washing machine with cover’s depth
between 48 and 60 cm.
Read carefully the instructions supplied
with the kit.
P1107
Door reversal
To make it easier to load or unload the
laundry the door can be reversed.
This operation must be carried out by
qualified personnel.
Please contact the nearest Electrolux
Service Centre.
TThhiiss wwiillll bbee aa cchhaarrggeeaabbllee ooppttiioonn..
Electrical connection
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent
person.
WARNING: THIS APPLIANCE MUST
BE EARTHED.
The manufacturer declines any
liability should this safety measure
not be observed.
Before switching on, make sure the
electricity supply voltage is the same as
that indicated on the appliance’s rating
plate. (See picture on page 5).
The appliance is supplied with a 13amp
plug fitted.
In the event of having to change the fuse
in the plug supplied, a 13amp ASTA
approved (BS1362) fuse must be used.
Should the plug need to be replaced for
any reason, proceed as described
below.
The wires in the mains lead are coloured
in accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
125986421_gb.qxp 2007-09-14 09:12 Page 26