Electrolux EDC47130W Clothes Dryer User Manual


  Open as PDF
of 20
 
electrolux something not working 15
Something not working
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that
the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Oncetheproblemhasbeeneliminated,press
the Start/Pause button to restart the program.
If after all checks, the problem persists, contact
your local Service Centre.
Malfunction Possible cause Solution
Dryer does
not work
•Mainsplugisnotpluggedinorfuseisnot
working correctly
•Loadingdoorisopen
•HaveyoupressedtheSTART/PAUSEbutton?
•Pluginatmainssocket
Check fuse in fuse box (domestic installation)
•Closeloadingdoor
•PresstheSTART/PAUSEbuttonagain
Drying results
unsatisfactory
•Wrongprogramselected
•Lintlterclogged
•Condenserunitcloggedwithlint
•Incorrectloadsize
•Ventilationslotsinbaseareacoveredup
•Residueoninsidesurfaceofdrumordrumribs
•Selectadifferentprogramthenexttime
youusethedryer(see“Overviewof
programs” section).
•Cleanlintlter
•Cleancondenserunit.
•Observerecommendedloadingvolumes.
•Uncoverventilationslotsinbasearea.
•Cleaninsidesurfaceofdrumanddrumribs
Loading door
does not close
•Finestrainernotinplaceand/orlargemesh
filter not locked in place.
•Installnestrainerand/orsnaplargemesh
filter into place
When pressing
a button, the
corresponding
button flashes
several times.
•Washingprotection
After the start of the program, the option can
no longer be set
•TurntheprogramknobtoOFF.
Set the program again
Drying cycle
ends shortly
after program
starts. END
light illuminated
•Notenoughwashingloadedorwashing
loaded is too dry for selected program.
•Selecttimeprogramorhigherdryinglevel
(e.g.EXTRADRYinsteadofCUPBOARD).
Program
inactive, Water
tank full light
illuminated
•WaterTankisfull •Emptywatertank,thenstartprogram
withSTART/PAUSEbutton.
Drying cycle
lasts an
unusually long
time.
Note: After
around 5 hours
the drying cycle
ends automatically
(see “Drying cycle
complete“)
•Lintlterclogged
•Condenserunitcloggedwithlint
•DELICATEbuttonpressedandloadvolume
too big
•Loadsizetoobig
•Laundryinsufcientlypre-drained
•Cleanlintlter
•Cleancondenserunit
•DELICATEisonlysuitableforusewithloads
of up to 3 kg!
•Reduceloadsize
•Laundrymustbesufcientlyspunand/or
adequatelypre-drained
EMAN_EDC4713OW_Feb09.indd 15 16/3/09 11:26:51 AM
 previous next