Filter
Top Products
28
The washing machine vi-
brates when operating or is
not stable.
Transit bar has not been
removed.
Removing the transit bar.
The screw feet not cor-
rectly adjusted.
Adjust feet according to the
Installation and Connection
instructions.
There is very little wash-
ing in the drum (e. g.,
just one bathrobe).
This does not affect how the
machine operates.
Water is running out from
under the washing
machine.
Screw connection on the
inlet hose is leaking.
Screw the inlet hose in firmly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in
the door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Display shows: “Excess De-
tergent”
Probably too much de-
tergent has been used.
Dose detergent exactly as in-
structed by manufacturer.
Display shows:
– “No drain/Check drain
hose/filter” or
– “Pump Blocked”
Kink in drain hose. Remove kink.
Maximum pumping
height of 1m exceeded.
Please contact your Service
Force Centre
Drain pump is blocked.
Switch off the appliance. Pull
out mains plug.
Clean the drain pump. Re-
move foreign bodies from the
pump housing.
For sink spigot connec-
tions: spigot is blocked.
Clean out spigot.
Fabric softener not rinsed
in, compartment for ad-
ditives is filled with water.
Conditioner insert in the
compartment for addi-
tives is not correctly at-
tached or is blocked.
Clean the detergent dispenser
drawer, insert the conditioner
insert firmly.
Problem Possible cause Remedy