Filter
Top Products
16
End of the wash cycle/removing the washing
At the end of the programme, END lights up on the programme
progress display. The door can be opened as soon as the DOOR indicator
is lit green.
1.Open the loading door and remove the washing.
2.Turn the programme knob to OFF.
3.Close the water valve.
4.After washing, pull out the detergent drawer a little to enable it to dry
out. Keep the loading door very slightly open so that the washing ma-
chine can air.
If RINSE HOLD has been selected:
After the rinse hold, END lights up on the programme progress display.
The water must first be drained:
– Either turn the programme knob to OFF, then to DRAIN and press the
START/PAUSE button (the water is drained without spinning),
– or turn the programme knob to OFF and then to SPIN. Change the
spin speed if necessary and press the START/PAUSE button (the water
is drained and the washing spun).
Overdosing
3 If the OVERDOSING indicator is illuminated, too much detergent was
used in the previous programme. The next time you wash, observe the
detergent manufacturer’s instructions concerning amount of detergent
required, and the amount of items you wash in one load.