Filter
Top Products
20
The washing machine
vibrates when operating
or is not stable.
The transport lock has not
been removed.
Removing the transport lock.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
Screw connection on the in-
let hose is leaking.
Screw the inlet hose on
tightly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Wash water is foaming
excessively. At the end
of the washing cycle,
the spin stops. The
OVERDOSING indicator
lights up.
Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
E20 appears.
The END indicator
flashes 2x, and an
acoustic signal sounds
2x.
(Problems with water
inflow.)
Kink in drain hose. Straighten the hose.
Do not exceed the maxi-
mum pump height of 1m.
Please contact customer
service.
Drain pump is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
The sink spigot is blocked.
Clean the sink spigot.
Fabric softener was not
rinsed in, the compart-
ment w for condition-
ers is full of water.
Fabric softener insert in the
compartment for condition-
ers is not correctly attached
or is blocked.
Clean the detergent drawer,
insert the fabric softener
insert firmly.
Problem Possible cause Remedy