Electrolux 137067200 Washer User Manual


  Open as PDF
of 20
 
12
If your washer has this console:
If your washer has this console:
Empty washer’s drum and close door.1.
After you plug in the washer the first time: wake up the washer by pressing any button, rotate cycle 2.
knob to hand wash cycle, press the start button and then the cancel button.
Wake up the washer again by pressing any button, then immediately and simultaneously press and 3.
hold both the eco friendly and my favoritebuttonsfor5seconds,oruntiltheLCDdisplaychanges.
TheLCDwindowwilldisplay4.
INSTAL CYCLE and show estimated time of cycle completion. Press the
start button. The Installation Cycle will automatically test for if water has been turned on. At cycle
completion,theLCDwindowmaydisplayINSTAL PASS!, meaning your new washer is properly installed
and ready for use. If it prompts an action such as NO WATER, CHECK HOSES or
CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections be-
fore you attempt to use the washer.
Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.5.
After you plug in the washer the first time: wake up the washer by pressing any button and then follow 1.
thepromptsontheLCDUserInterface,includinglanguageselection.
The Installation Cycle will automatically test for, and if water has been turned on. At cycle completion, 2.
theLCDwindowmaydisplayINSTAL PASS!, meaning your new washer is properly installed and ready
for use. If it prompts an action such as NO WATER, CHECK HOSES or
CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections be-
fore you attempt to use the washer.
Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.3.
Please read the 6. Use & Care Guide and enjoy your new premium washer!
Please read the 4. Use & Care Guide and enjoy your new premium washer!
Installation Instructions
Performing Installation Cycle
NOTE
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the cancel
button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
NOTE
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the cancel
button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
 previous next