Electrolux 137064300A Washer User Manual


  Open as PDF
of 20
 
10
Run some water from the hot and cold faucets 1.
to flush the water lines and remove particles
that might clog the water valve screens and to
determine which faucet is hot and which is cold
supply.
Lookintheendofeachwatersupplyinlethose2.
and verify that the rubber washers are in place.
Connect the HOT inlet hose to the HOT water 3.
supplyandtheCOLDinlethosetotheCOLD
water supply. Tighten by hand until snug.
Tighten each supply connection another 2/3 4.
turn with pliers.
Turn on the water and check for leaks.5.
NOTE
HOTandCOLDwaterinlethosesarecolor
coded for identification. The HOT inlet hose is
markedwithaREDbandandtheCOLDinlet
hoseismarkedwithaBLUEband.
Connecting inlet water
RUBBER WASHERS
MUST BE PRESENT
Installation Instructions
 previous next