Filter
Top Products
8
Disposing of the collected
water
A) Empty the tank manually.
When the tank is full, remove and empty it
into a large sink or tub (fig.1).
When finished, replace it properly.
NOTE: The tank must be positioned properly
making sure slots on back of tank are positio-
ned correctly.
For the electronic model, if you hear the con-
tinual sound of the buzzer, it means the tank is
not in the proper position.
For the mechanical model, after removing
the tank, you must first wait 3 minutes to repla-
ce the tank.
B) Continuous draining.
Condensed water can be drained via a hose
connected to an outlet at the rear of the tank:
1. remove the water tank.
2. Using a 5 mm drill bit, drill a hole in the rear of
the tank along the torus like in figure 2.
3. connect a hose to the hose connector. Be
sure the hose does not kink or bend.
Make sure that the hose is not higher than the
hose connection (see figure 3).
NOTE: If you do not want to use the hose, you
can plug the hole with the rubber stopper
accessory.
fig. 1
fig. 2
fig. 3
Drill
Hose
Drain
GB 12-12-2003 16:15 Pagina 8