Filter
Top Products
6
ELECTRONIC MODEL
ON/OFF button
Press this button to start /stop the appliance. The compressor will respond to the modified
humidity setting 3 minutes after the unit is switched on.
MODE button
Press this button to select the Fan only or Dehumidifier modes.
Room temperature knob
Press this button to display the Temperature or Humidity reading on the LCD display.
If you press the button once the display will show the °F . If you press the button twice, the
display will show the temperature in °C. After few seconds, the display will automatically
show the humidity level.
FAN button
Press this button to select the High Fan Speed or Low Fan Speed settings.,
Press this button to increase the humidity level by 5% up to a limit of 80%RH.
Press this button to reduce the humidity level by 5%up to a limit of 30%RH. When the unit is
in continuous operation the LCD screen will display two dashes.
NOTE: If the set humidity level is higher than the level in the room, the compressor will stop
working, although the fan continues.
The default humidity setting is 60%RH
Control panel
Display
FAN
button
ON/OFF
button
MODE button
Room
temperature
knob
°F/ °C
Full Tank light
Operation
Increase humidity
level button
Decrease
humidity level
button
GB 12-12-2003 16:15 Pagina 6