Filter
Top Products
20 / EN
Washing Machine / User’s Manual
4.3.11.3 Adding or taking out laundry
1. Press the Start / Pause button to switch the machine to pause mode. The programme follow-up light of the
relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
5. Close the Loading Door.
6. Make changes in auxiliary functions, temperature and speed settings if necessary.
7. Press Start/Pause button to start the machine.
4.3.12 Child Lock
Use Child Lock function to prevent children from tampering with the machine. Thus you can avoid any changes
in a running programme.
C
You can switch on and off the machine with On / Off button when the Child Lock is active. When you switch on the
machine again, programme will resume from where it has stopped.
4.3.12.1 To activate the child lock:
Press and hold Auxiliary Function button 2 for 3 seconds. In the programme selection display on the panel,
"Child lock enabled" light will turn on. You can release Auxiliary Function button 2 when this warning is
displayed.
4.3.12.2 To deactivate the child lock:
Press and hold Auxiliary Function button 2 for 3 seconds. In the programme selection display on the panel,
"Child lock enabled" light will turn off.
4.3.13 Canceling the programme
The programme is cancelled when the machine is turned off and on again. Press and hold On / Off button for
3 seconds.
C
If you press On / Off button when the Child Lock is enabled, the programme will not be cancelled. You should cancel the
Child Lock first.
If you want to open the loading door after you have cancelled the programme but it is not possible to open the loading door
since the water level in the machine is above the loading door opening, then turn the
Programme Selection knob to
Pump+Spin programme and discharge the water in the machine.
4.3.14 End of programme
End LED appears on the display when the programme is completed.
If you do not press any button for 10 minutes, the machine will switch to OFF mode. Display and all indicators
are turned off.
Completed programme steps will be displayed if you press On / Off button.
4.3.15 Your machine features "Standby Mode".
After you switch on your machine with On-Off button, if no program is started or no other procedure is
performed at the selection step or no action is taken within approx. 10 minutes after the selected program
ends, your machine will switch to OFF mode automatically. Display and all indicators are turned off. Selected
programme data will be displayed if you press On / Off button. Before you start the program, check the
accuracy of your selections. If necessary, repeat them. This is not an error.