Filter
Top Products
Page 8
Warning: The drain hose must be
securely fitted for good water flow
and to avoid risk of flooding or injury.
Fitting the water supply hose to the
washing machine:
Hold the hose and turn the nut clockwise.
Firmly hand tighten the nut.
To remove the hose, switch off the tap and
then turn the nut counter clockwise.
Fitting the drain hose
The hose should not be twisted, bent or
squeezed shut and must not be stepped on.
1. Compress the two ears of the drain hose
clamp with your hands and connect the
drain hose to the pump outlet. Fix the
clamp in place.
CAUTION: Ensure the height of drain
hose is not less than 700 mm. The
machine will not operate properly if
the hose is less than 700 mm high.
2. Pull the outlet end of the drain hose
upwards and fix it with the hose clamp on
the rear of the washing machine cabinet.
3. When the machine is not in use, hang the
drain hose on the recess on the right side
of the machine cabinet. When the
machine is in operation, place the outlet
end of the drain hose into the sink or a
dedicated drainage outlet.
Warning: Ensure that the cold and hot
water connections are made correctly
when installing the machine.
Warning: Do not use water that is
hotter than 50ºC