Filter
Top Products
INSTALLATION - CONTINUED
INLET HOSES
• Connect the respective inlet hoses to the hot and cold water taps and to the machine’s inlet
fittings. (see sketches below). The hot water inlet is on the left and the cold water inlet on
the right.
CONVENTIONAL TAPS
1
Pull down the collar of the
inlet valve to separate it
from the water tap adaptor.
2
Loosen the four screws
in the water tap adaptor.
3
Fit the tap adaptor to the
tap so that the rubber seal
fits snugly. Then tighten
the four screws evenly.
4
Remove the tape and
screw (B) into (A).
5
Connect the inlet hose to
the water tap adaptor.
6
Attach the other end of
the hose to the machine
inlet by turning it clock-
wise until tight.
FOR THREADED TAPS
HOSE
CONNECTOR
WASHER
CONNECTOR INLET
CONNECTOR
HOSE
WASHER
Open the water taps and check for any leaks. Tighten fittings if necessary.