Filter
Top Products
Page 5
Features 6
Programmes
•
There are:
•
Timed programmes of 60, 40. 20 and 10
minutes)
•
Two synthetic programmes (Ready to
iron and Ready to wear)
•
Three cotton programmes (Extra dry,
Ready to wear and Ready to iron)
•
A Delicates programme
• A Freshen up programme.
•
The programme selector knob may be turned
in either direction to select the required pro-
gramme.
• Always choose a programme which is suitable
for the fabric type and observe the symbols on
garment care labels.
•
With a little practice you will soon determine
which programme suits your requirements.
Anti Crease
• The laundry may be removed after a drying
cycle has been completed.
• Alternatively, the laundry may be left in the
drum, in which case the machine will auto-
matically perform an Anti Creasing phase.
• Throughout this phase he laundry is separated ,
smoothed and cooled. The Anti creasing indi-
cator will flash and the drum will rotate briefly
every 60 seconds for about 2 hours.
Buzzer
• At the end of a drying programme and
throughout the Anti creasing phase, a buzzer
(Chime on certain models) will sound.
• If this is annoying, the buzzer may be muted
by pressing the Buzzer Cancel button.
Control panel lock
• To prevent accidental operation of the dryer,
the controls may be locked.
• Press the Buzzer Cancel and the Start/Pause/
Cancel buttons simultaneously and hold down
for 3 seconds. (To unlock, repeat the proce-
dure).
• One of the progress indicators will flash.
• When the dryer is in locked mode, only the
ON/OFF button will function.
• The lock may be activated during operation or
in standby mode.
Pull the lint filter out and open it
Unfold the filter and carefully remove the accumu-
lated lint using a soft cloth.
Fold, close and return the filter to its housing.
Drum ribs
Humidity sensors are located
on the inside of the drum ribs.
These determine when the
laundry is dry. The ribs
should be cleaned every three
months. Wait till the dryer
has cooled down and wipe the ribs with a soft cloth
dipped in vinegar, then wipe dry.
Programme progress indicators
This vertical row of indicators show which phase
of the drying cycle is operational.
The door
• Open the door by pulling on the handle
• Opening the door will automatically stop the
dryer operation.
• To close the door , push until a click is heard.
• If required, the door hinging may be reversed
so that the door opens from right to left.
• Note . Activating the control panel lock, does
not lock the door.
Drying
Ready to iron
Ready to wear
End -Anti crease
Lint filter
It is essential that the lint filter be cleaned after
every drying cycle
At the end of a programme the indicator will
glow as a reminder to clean the filter.