Filter
Top Products
Page 12
CLEANING THE WATER INLET FILTER
• Water intake filters are located at the machine inlet valve and at the tap end of the inlet hose.
These filters prevent dirt from entering the machine and should be cleaned periodically.
(every 30 to 40 washes.)
• Close the tap and disconnect the inlet hose.
• Clean the filters with a bristle brush .
•
If the filter is very dirty it may have to be pried loose with a pair of pliers.
CLEANING THE PUMP FILTER
• The filter prevents foreign objects from entering and damaging the pump. This filter should be
cleaned after every 30-40 washes.
• First disconnect the machine from the power supply.
• Using a coin, open the filter cover located at the lower front of the machine.
• Pull the small hose partially out, remove the small plug at the end of the hose and empty the drain
water into a suitable receptacle placed on the floor below the hose. When all the drain water has
discharged, replace the plug and feed the hose back into the machine.
• Unscrew and remove the filter. Some residual water may leak onto the filter cover.
• Remove any debris and clean the filter before replacing it.
•
Mop up any spillage and close the filter cover.
GENERAL CLEANING
• On no account use benzene or other solvents to clean the cabinet, door or rubber of the machine.
• A damp cloth will normally suffice.
•
If desired, a good wax polish may be used on the painted parts of the cabinet.
HOSES
• Periodically inspect the hoses for cracks or deterioration.
•
Worn hoses should be replaced and are available from the nearest Defy Service Centre.
Please note that the following are not covered by the warranty.
• Damage to exterior finish.
• Breakage of the door glass.
• Damage through improper installation.
• Damage caused through improper use of the appliance.
• Damage caused by moving or transporting the appliance.
Owner’s responsibility