Filter
Top Products
5
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the
cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
For Screw-Shaped Tap
INLET HOSE CONNECTION
1 Pull down the collar of the
inlet hose to separate it
from the water tap
adapter.
2 Loosen the four screws
properly in order to fit into
water tap.
3 Fit the water tap adapter
into the water tap and
tighten the four screws
evenly while pushing up
the adapter so that the
rubber packing can stick
to the water tap tightly.
4 Remove the tape, and
screw connector B into
connect A tightly.
5 Connect the inlet hose to
the water tap adapter by
pulling down the collar of
the hose end.
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer
by turning it clockwise to
be fixed tightly.
• Please check the rubber
packing present inside the inlet
hose adapter of the hose.
1 Connect the inlet hose to
the water tap by screwing
the connector tightly.
2 Connect the connector-
inlet supplied if necessary.
3Connect the inlet hose
adapter to the water inlet
of a washer and turn it to
be fixed.
*Check the packing in the inlet
TAPE
Connector B
Connector A
Connector
Connector
Rubber
Packing
Hose
Connector
Rubber
Packing
Hose
Connector
inlet
Connector