Filter
Top Products
8
2. Insert cord brackets into slotted holes in rear panel and secure
with screws provided.
B
A
C
A.Cord bracket
B. Slotted hole
C.Screw
NOTE: Power supply cord may be wrapped around the brackets for
storage convenience when dryer is not in use.
Install casters
1. Lay dryer on its side.
2. Use carton to avoid damage to dryer.
3. Screw casters into dryer base at four corners and tighten
securely.
4. Set dr
yer upright. In doing so, be certain that dryer does not roll
away from you.
NOTE: Permanent installations r
equire 4 dryer feet. See “Assistance
or Service” section for information on ordering.
Connect Vent
1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sur
e the vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhau
st hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2. Mo
ve dryer into its final location. Avoid crushing or kinking vent.
3. (On gas models) Ch
eck that there are no kinks in the flexible gas
line.
4. Once exhaust
vent connection is made, remove corner posts and
cardboard.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
2. Ch
eck that you have all of your tools.
3. Dispose of/r
ecycle all packaging materials.
4. Check dryer’s final location. Be sure vent is not crushed or kinked.
5. Ch
eck that dryer is on a level surface.
6. P
lug into a grounded 3 prong outlet. Turn power on.
7. Remove film on console and any tape remaining on dryer.
Remove tape from the lint screen (located on inside back wall
of dryer).
8. Read “Dryer Use.”
9. Wipe d
ryer drum interior thoroughly with a damp cloth to remove
any dust.
10. T
o test the dryer, set the dryer on a full heat cycle (not an air cycle)
for 20 minutes and start the dryer.
If the dryer will not start, check the following:
■ Controls are set in a running or “On” position.
■ Push to Start button has been firmly pressed.
■ Dryer is plugged into a grounded 3 prong outlet.
■ Electrical supply is connected.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the dryer
door and feel for heat. If you feel heat, cancel cycle and close
the door.
If you do not feel heat, check the following:
■ Controls are set on a heated cycle, not an air cycle.
NOTE: Y
ou may notice an odor when dryer is first heated. This odor
is common when the heating element is first used. The odor will go
away.