Filter
Top Products
8
C
ycles, options, lights
W
hat can & cannot be
washed
o
perating tips
dishwasher use
l
oading
C
ontrols at a glance
Dryer Exhaust tips
S
afety
Care & Cleaning
Service & Warranty
S
urface Cooking
t
roubleshooting
Oven Cooking
Storing the washer
S
pecial Features
Care And Cleaning
Care and Cleaning
Control Panel – clean with a soft, damp cloth. Do not
use abrasive substances. Do not spray cleaners
directly on the panel.
Tumbler – remove any stains such as crayon, ink pen
or fabric dye (from new items such as towels or jeans)
with an all-purpose cleaner. Then tumble old towels or
rags to remove any excess stains or cleaning
substances. Once these steps are done, stains may still
be visible, but should not transfer to subsequent loads.
Cabinet – wipe off any marks with soap and water.
Dryer Exhaust System – should be inspected and
cleaned once a year to maintain optimum performance.
The outside exhaust hood should be cleaned more
frequently to ensure proper operation. (Refer to the
Installation Instructions for more information.)
Replace Drum Light
Instructions for replacing the bulb:
1. Unplug or disconnect the dryer from the electrical
power supply.
2. Open the door and use a Phillips screwdriver to
remove the screw attaching the lens to the tumbler
front.
3.
Remove lens cover by pulling cover toward center
of tumbler.
4. Rotate bulb
counter-clockwise to remove from
socket.
5. Replace the bulb with a 120 volt, 10 watt maximum
candelabra base light bulb.
6. Turn the light bulb
clockwise into socket.
7. Replace lens cover by hooking plastic tabs into
tumbler front below the light housing.
8. Reinstall the screw into the lens cover screw hole.
9. Reconnect dryer to power supply.
Reverse the Door
Instructions for reversing the dryer door:
1. Remove the hinge hole covers and screws.
2. While supporting the door, remove 2 screws in the
hinge
s that secure the hinge
s to the c
abinet.
3. Remove door by lifting slightly at the hinges and
pulling the hinge tabs out of the hinge slots.
4. Move the following parts to the opposite side of
the door: 2 hinges and 4 hinge screws, 4 door
screws, door strike and screw, inner door cover
plate and screw.
5. Attach the door to the opposite side of the
cabinet using the 2 counter sunk hinge screws.
(See below).
Screw the lower hinge screw in first. This will help
to align the door and hinges.
6. Replace the hinge hole covers to the opposite side.