Creda TVU1 TVR2 Clothes Dryer User Manual


 
Troubleshooting
12
GB
Problem:
The dryer won’t start.
It is taking a long time to dry.
Possible causes / Solution:
The plug is not plugged into the socket, or not making contact.
There has been a power failure.
The fuse has blown. Try to plug another appliance into the socket.
You are using an extension cord? Try to plug the dryer’s power cord
directly into the socket.
The TIMER knob has not been set properly (see Start and Programmes).
The START button has not been pressed (see Start and Programmes).
The START button was pressed with the door open. Make sure the door is
closed before pressing the START button (see Start and Programmes).
! If the START button is pressed with the door open the dryer will not
start. Close the door, wait for a few seconds and then press the START
button again (see Start and Programmes).
The filter has not been cleaned (see Maintenance).
The temperature setting is not ideal for the type of fabric you are drying
(see Start and Programmes).
The correct programme has not been selected for the load (see Start
and Programmes).
The flexible vent tube is obstructed (see Installation).
The air intake vent is obstructed (see Installation).
The permanent ventilation flap on the storm cover is obstructed (see
Installation).
The items were too wet (see Laundry).
The dryer was overloaded (see Laundry).
One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the
following troubleshooting suggestions: