Filter
Top Products
Installation
Description
Start and
Programmes Laundry
Warnings and
Suggestions
Maintenance and
Care Troubleshooting Service
GB
5
Start and Programmes
Choosing a programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean
and in place (see Maintenance).
4. Load the machine and make sure items are not
in the way of the door seal. Close the door.
5. Choose a drying time or programme, the way you
do this depends on the type of dryer you have:
Unidirectional dryers: Model TVU1
Choose a drying time by
checking the Drying Guide table
for the type of fabric you are
drying (see Laundry).
- set the temperature with the
HEAT button.
- select a drying time by rotating
the TIMER knob clockwise, slightly past the time
that you want to select and counter-clockwise, until
the indicator is pointing to the drying time you
want.
Reversing dryers: Model TVR2
Choose a drying time by
checking the Drying Guide table
for the type of fabric you are
drying (see Laundry).
- set the temperature with the
HEAT button.
- select a drying time by rotating
the TIMER knob clockwise, never counter-clockwise,
until the indicator is pointing to the drying time you
want.
Reversing Sensor dryers: Model TVS3
Choose a drying programme by
checking the Programmes table
(see Programmes) as well as
the indications for the type of
fabric (see Laundry).
- set the temperature with the
HEAT button.
- select a programme or drying
time by rotating the PROGRAMME knob clockwise,
never counter-clockwise, until the indicator is pointing
to the drying time or programme you want.
6. (Model TVS3 only) If you wish the buzzer to
sound at the end of the drying cycle: press the
ALARM button.
7. Press the START button to begin.
During the drying cycle you can check on your
laundry and take out the items that are dry, while
the others continue drying. When you close the
door again, press START in order to resume drying.
8. About 10 minutes before drying is completed, it
enters the final COOL TUMBLE phase (fabrics
are cooled), which should always be allowed to
be completed.
9. (Model TVS3 only) The buzzer, if Alarm was
selected, will warn you when drying is complete.
10. Open the door, take the laundry out, clean the filter
and replace it (see Maintenance).
11. Unplug the dryer.