Filter
Top Products
Choosing a programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean
and in place and the water container is empty
and in place (see Maintenance).
4. Load the machine and make sure items are not
in the way of the door seal. Close the door.
5. Choose a drying programme by checking the
Programmes table (see Programmes) as well as
the indications for the type of fabric (see
Laundry).
- Set the temperature with the HEAT button.
- Select a programme or drying time by rotating
the PROGRAMME knob.
4
6. If you wish the buzzer to sound at the end of the
programme, press the ALARM button.
7. Press the START button to begin.
During the drying programme, you can check on
your laundry and take out items that are dry
while others continue drying. When you close
the door again, press the START button in order
to resume drying.
8. About 10 minutes before the programme is
completed, it enters the final COOL TUMBLE
phase (fabrics are cooled), which should always
be allowed to complete.
9. Open the door, take the laundry out, clean the
filter and replace it. Empty the water container
and replace it (see Maintenance).
10. Unplug the dryer.
Start and Programmes
GB
Water container and empty water light
If you have plumbed your dryer to a drain this light can be ignored, as there is no need to empty the water
container.
When this light is on (not flashing) it reminds you to empty the water container.
If the water container fills during a programme, the light flashes and the dryer does the Cool Tumble phase (see
Programmes). You must empty the water container and restart the dryer or the clothes will not dry. After
re-starting the dryer the light will take a few seconds to go out.
To avoid this always empty the water container each time you use the dryer (see Maintenance).