Filter
Top Products
16
4
Remarks:
Freely programmable stop-function
Before starting a program it is possible to preprogram a time stop in every
program segment. This function permits special additional functions like adding
bleach or extra detergent to the wash bath.
Programming:
After selecting the program, press the ECO-button (E) and keep it depressed.
Now push the START-button (S) simultaneously and release same. Only now
release the ECO-button (E).
The left display now shows “StO” (Stop) and the right display shows the program
number. The first program sequence LED is switched on.
Confirm by pressing the START-button (S) if a time stop is required in this phase
of the program. If no time stop is needed, press the ECO-button (E) to move on
to the next segment of the program. Run through the entire program in this way.
If needed, return to previous segments by pressing the SELECT-button (P).
Errors can be corrected by returning to the erroneously programmed time stop
in the segment and correcting by pressing the START-button (S).
After the final program segment all programmed time stops will be displayed and
the left display will show “End”. Confirm this program by pressing the START-
button (S) again. Now start the program.
Operation:
When a stop is reached during the run of the program, the time will be stopped.
The wash bath will be filled to the appropriate level and temperature and the
programmed wash action is executed.
The left display will alternately show temperature and “StO”, while the central
display is showing “F1”. Now, if so desired, additional detergents can be added.
When this has been done, press the START-button (S) to continue the run of
the program. To remove any possible remains of corrosive products in the tub,
the machine will rinse an additional 2 seconds.
Programmable automatic start
By using this function a program can be started up to 99 hours later.
Programming:
After selecting the program, press the SELECT-button (P) again and keep it
depressed.
Now push the START-button (S) simultaneously and release same. Only now
release the SELECT-button (P).
The left display now shows “DEL” (Delay). The central display shows “10”
(minutes). Every push on the SELECT-button (P) will add 10 minutes to the
delayed start time. Hours and minutes are separated by a decimal point: 1.5 stands
for 1 hour and 50 minutes. After 10, the counting is done by hours.
By pressing the ECO-button (E), the delay time can be counted down.
Operation:
After having set the desired delay time, the count-down can be started by
pressing the START-button (S). During the count-down the displays blink and
the remaining time is counted down. In the last hour the displays blink faster.
When the delay time has elapsed, the program is started automatically.