Filter
Top Products
8
3
Remove the cover plate at the back of the machine (see dimensions).
Connect the power cable to the connectors R,S,T (3 x 220V) or R,S,T and
N (3 x 380V + N) and the ground wire.
p
Electrical Connection
The machine is equipped with a drain valve with 3" outer diameter (80 mm).
This drain valve should be connected to the drain by means of the drain
elbow which is delivered with the machine.
The diameter of the main drain should be adapted to the water flow and
the number of machines. It should be sufficient to handle at least 160L/
min. per machine.
It is necessary to connect the main drain at least on one side to an open
air-brake to allow ventilation.
When the main drain has not been sufficiently deodorized, every
machine should be installed seperately with a deodorizer.
p
p
p
Water drain
p
After having connected the machine, check the spin direction of the drum. The drum should spin in the
direction of the arrow indicated on the door glass (clockwise). If the drum spins in the wrong sense, it can
cause damage to the motor and can cause water to splash out through the soap dispenser.
In case of a wrong spin direction, switch the position of the connectors of the motor circuit from R to S
and vice versa.
Machine with electrical heating
Power of the breaker plugs:
220V 3AC 380V 3AC + N
27 kW 80 A 63 A
36 kW ---- 80 A
Power of the breaker plugs:
220V 3AC 380V 3AC + N
20 A 20 A
Machine without electrical heating