Blomberg WNF 7221 WE20 Washer User Manual


  Open as PDF
of 68
 
14
EN
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush.Ifthefiltersaretoodirty,takethemoutby
means of pliers and clean them. Take out the filters
on the flat ends of the water intake hoses together
with the gaskets and clean thoroughly under
running water. Replace the gaskets and filters
carefully in their places and tighten the hose nuts
byhand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
itemssuchasbuttons,coinsandfabricfibers
clogging the pump impeller during discharge of
washingwater.Thus,thewaterwillbedischarged
withoutanyproblemandtheservicelifeofthe
pump will extend.
Ifthemachinefailstodrainwater,thepumpfilter
isclogged.Filtermustbecleanedwheneverit
iscloggedorinevery3months.Watermustbe
drained off first to clean the pump filter.
Inaddition,priortotransportingthemachine(eg.,
when moving to another house) and in case of
freezingofthewater,watermayhavetobedrained
completely.
A
 Foreignsubstancesleftinthepumpfiltermay
damage your machine or may cause noise
problem.
Inordertocleanthedirtyfilteranddischargethe
water:
Unplugthemachinetocutoffthesupplypower.
A
Temperature of the water inside the machine
mayriseupto90ºC.Toavoidburningrisk,
filtermustbecleanedafterthewaterinthe
machine cools down.
Openthefiltercap.
Ifthefiltercapiscomposedoftwopieces,
pressthetabonthefiltercapdownwardsand
pull the piece out towards yourself.
Ifthefiltercapisonepiece,pullthecapfromboth
sides at the top to open.
C
Youcanremovethefiltercoverbyslightly
pushing downwards with a thin plastic tipped
tool,throughthegapabovethefiltercover.
Donotusemetaltippedtoolstoremovethe
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequently
facedproblemsdecreaseifcleanedatregular
intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every4-5washingcycles)asshownbelowin
order to prevent accumulation of powder detergent
in time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
Ifmorethannormalamountofwaterand
softener mixture starts to gather in the softener
compartment,thesiphonmustbecleaned.
Wash the detergent drawer and the siphon with
plentyoflukewarmwaterinawashbasin.Wear
protectiveglovesoruseanappropriatebrushto
avoid touching of the residues in the drawer with
yourskinwhencleaning.Insertthedrawerback
into its place after cleaning and make sure that it is
seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected
tothetap.Thesefilterspreventforeignsubstances
and dirt in the water to enter the washing machine.
Filtersshouldbecleanedastheydogetdirty.
Cancel light will flash continuously to notify that the
programmehasbeencanceled.
Your machine will end the programme when you
turntheProgrammeSelectionknob;however,it
does not drain the water inside. When you select
and start a new programme, the newly selected
programme will start depending on the step
the previous programme was canceled in. For
example, it may take in additional water or continue
to wash with the water inside.
C
Dependingonthestepwherethe
programme was canceled in, you may have
to put detergent and softener again for the
programme you have selected anew.
 previous next