Filter
Top Products
24
EN
Follow-up indicator. At the beginning
of every programme step, the relevant
indicator light will turn on and light of the
completed step will turn off.
You can change the auxiliary functions,
speed and temperature settings without
stopping the programme flow while the
programme is running. To do this, the
change you are going to make must be in
a step after the running programme step.
If the change is not compatible, relevant
lights will flash for 3 times.
C
If the machine does not pass to the
spinning step, Rinse Hold function
might be active or the automatic
unbalanced load detection system
might be activated due to the
unbalanced distribution of the laundry
in the machine.
Loading door lock
There is a locking system on the loading
door of the machine that prevents
opening of the door in cases when the
water level is unsuitable.
Loading door light will start flashing when
the machine is switched to Pause mode.
Machine checks the level of the water
inside. If the level is suitable, Loading
Door light illuminates steadily within 1-2
minutes and the loading door can be
opened.
If the level is unsuitable, Loading Door
light turns off and the loading door cannot
be opened. If you are obliged to open
the Loading Door while the Loading
Door light is off, you have to cancel the
current programme; see "Canceling the
programme".
Changing the selections after
programme has started
Switching the machine to pause
mode
Press the Start / Pause button to switch
the machine to pause mode while a
programme is running. The light of the
step which the machine is in starts
flashing in the Programme Follow-up
indicator to show that the machine has
been switched to the pause mode.
Also, when the loading door is ready to
be opened, Loading Door light will also
illuminate continuously in addition to the
programme step light.
Changing the speed and temperature
settings for auxiliary functions
Depending on the step the programme has
reached, you may cancel or activate the
auxiliary functions; see, "Auxiliary function
selection".
You may also change the speed and
temperature settings; see, "Spin speed
selection" and "Temperature selection".
C
If no change is allowed, the relevant light
will flash for 3 times.
Adding or taking out laundry
1. Press the Start / Pause button to
switch the machine to pause mode.
The programme follow-up light of the
relevant step during which the machine
was switched into the pause mode will
flash.
2. Wait until the Loading Door can be
opened.
3. Open the Loading Door and add or take
out the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions,
temperature and speed settings if
necessary.
6. Press Start / Pause button to start the
machine.
Canceling the programme
To cancel the programme, turn the
Programme Selection knob to select
another programme. Previous programme
will be canceled. End / Cancel light will flash
continuously to notify that the programme
has been canceled.
Your machine will end the programme
when you turn the Programme Selection
knob; however, it does not drain the water
inside. When you select and start a new
programme, the newly selected programme
will start depending on the step the previous
programme was canceled in. For example,
it may take in additional water or continue to
wash with the water inside.
C
Depending on the step where the
programme was canceled in, you may
have to put detergent and softener
again for the programme you have
selected anew.