Blomberg TKF 8439 A Clothes Dryer User Manual


 
23
EN
There are humidity sensors in your dryer
that detect whether the laundry is dry or
not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if
drying has been carried out.
3. Wipe the metal sensors with a soft
cloth, dampened with vinegar and dry
them.
C Clean metal sensors 4 times a year.
A Never use solvents, cleaning agents
or similar substances when cleaning
since these materials can cause fire and
explosion!
Water tank;
The moisture in the damp laundry is taken
from the laundry and condens ed. Drain
the water tank after each drying cycle or
during drying when “Water tank” warning
light turns on.
A Condensed water is not drinkable!
A Never take out the water tank when the
programme is running!
- Inside the drawer on the panel
- Behind the kick plate cover
If you forget to drain the water tank, your
dryer will stop during the following
drying cycles when the water tank is
full and the “Water tank” warning light
will turn on. If this is the case, press the
“Start/Pause/Cancel” button to resume
the drying cycle after draining the water
tank.
To drain the water tank:
1. Drain the water as shown on the
picture .
7 Maintenance and cleaning
Filter Cartridge / Door Inner
Surface
Lint and fibres released from the laundry to
the air during the drying cycle are collected
in the “Filter Cartridge”.
CSuch fibre and lint are generally formed
during wearing and washing.
C Always clean the filter and the inner
surfaces of the cover after each drying
process.
C You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up
and open the filter.
3. Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C Clogging may arise on the filter surface
after using your machine for some time;
if this occurs, wash the filter with water
and dry it before using again.
C Clean the entire inner surface of the
cover and door gasket.
Sensor