Blomberg AE20 Washer User Manual


  Open as PDF
of 71
 
4
EN
come out excessively wet. Therefore, follow
theheightsdescribedinthefigure.
• Topreventflowingofdirtywaterbackintothe
machine and to allow for easy discharge, do
not immerse the hose end into the dirty water
ordriveitinthedrainmorethan15cm.Ifitis
too long, cut it short.
• Theendofthehoseshouldnotbebent,it
shouldnotbesteppedonandthehosemust
notbepinchedbetweenthedrainandthe
machine.
• Ifthelengthofthehoseistooshort,useit
byaddinganoriginalextensionhose.Length
ofthehosemaynotbelongerthan3.2m.
To avoid water leak failures, the connection
betweentheextensionhoseandthedrain
hoseoftheproductmustbefittedwellwithan
appropriate clamp as not to come off and leak.
Adjusting the feet
A
 Inordertoensurethattheproductoperates
moresilentandvibration-free,itmuststand
levelandbalancedonitsfeet.Balancethe
machinebyadjustingthefeet.Otherwise,the
product may move from its place and cause
crushingandvibrationproblems.
1. Loosenthelocknutsonthefeetbyhand.
2. Adjust the feet until the product stands level
andbalanced.
3. Tightenalllocknutsagainbyhand.
A
 Donotuseanytoolstoloosenthelocknuts.
Otherwise,theywillgetdamaged.
Electrical connection
Connect the product to a grounded outlet
protectedbyafusecomplyingwiththevaluesin
the"Technicalspecifications"table.Ourcompany
shallnotbeliableforanydamagesthatwillarise
when the product is used without grounding in
accordance with the local regulations.
• Connectionmustcomplywithnational
regulations.
• Powercableplugmustbewithineasyreach
after installation.
• Thevoltageandallowedfuseorbreaker
protection are specified in the “Technical
specifications”section.Ifthecurrentvalueof
thefuseorbreakerinthehouseislessthan16
Amps,haveaqualifiedelectricianinstalla16
Amp fuse.
• Thespecifiedvoltagemustbeequaltoyour
mains voltage.
• Donotmakeconnectionsviaextensioncables
ormulti-plugs.
B
 Damagedpowercablesmustbereplacedby
the Authorized Service Agents.
First use
Beforestartingtousetheproduct,makesure
that all preparations are made in accordance
withtheinstructionsinsections"Importantsafety
instructions"and"Installation".
To prepare the product for washing laundry, perform
firstoperationinDrumCleaningprogramme.If
yourmachineisnotfeaturedwithDrumCleaning
programme,useCottons-90programmeand
select Additional Water or Extra Rinse auxiliary
functionsaswell.Beforestartingtheprogramme,
putmax.100gofpowderanti-limescaleintothe
main wash detergent compartment (compartment
nr.II).Iftheanti-limescaleisintabletform,putonly
onetabletintocompartmentnr.II.Drytheinside
ofthebellowwithacleanpieceofclothafterthe
programme has come to an end.
C
Useananti-limescalesuitableforthewashing
machines.
C
Some water might have remained in the
productduetothequalitycontrolprocesses
 previous next