Filter
Top Products
2
1
When using your iron, basic safety precautions should always be followed,
including the following:
❑
READ ALL INSTRUCTIONS BEFORE USING.
❑
Use iron only for its intended use.
❑
To protect against a risk of electric shock, do not immerse the iron
in water or other liquids.
❑
The iron should always be turned to “Off” before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead grasp plug
and pull to disconnect.
❑
Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around the iron when storing.
❑
Always disconnect iron from electrical outlet when filling with water
or emptying and when not in use.
❑
Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble
the iron, take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the
iron is used.
❑
Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
❑
Burns can occur from touching hot metal parts, hot water, or steam.
Use caution when you turn a steam iron upside down- there may
be hot water in the reservoir.
SPECIAL INSTRUCTIONS
❑
To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
❑
If an extension cord is absolutely necessary, a 10-ampere cord should
be used. Cords rated for less amperage may overheat. Care should
be taken to arrange the cord so that it cannot be pulled or tripped over.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
Soft-Touch Parts
Note: The soft-touch parts of this unit are free of natural rubber and latex.
They are safe for individuals allergic or sensitive to these materials.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug will fit into a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not attempt to modify the plug
in any way.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent
removal of the outer cover. To reduce the risk of fire or electric shock, do not
attempt to remove the outer cover. There are no user-serviceable parts
inside. Repair should be done only
by authorized service personnel.
Note: If the power supply cord is damaged, it should be replaced by
qualified personnel or in Latin America by an authorized service center.
D5000Pub1000003116 6/21/06 2:08 PM Page 2