Filter
Top Products
5
TIP OF THE SANDING BASE (FIGURE B)
• When the sanding base tip is worn, it can be reversed or replaced.
• Reverse or replace the worn part.
WARNING: Fire hazard. When working on metal surfaces, do not
use a vacuum cleaner because sparks are generated. Wear safety
glasses and a dustmask. Due to the danger of fire, do not use your
sander to sand magnesium surfaces. Do not use for wet sanding.
HINTS FOR OPTIMUM USE
• Do not exert too much pressure on the tool.
• Regularly check the condition of the sanding sheet. Replace when necessary.
• Always sand with the grain of the wood.
• When sanding new layers of paint before applying another layer, use extra fine grit.
• On very uneven surfaces, or when removing layers of paint, start with a coarse grit. On other
surfaces, start with a medium grit. In both cases, gradually change to a fine grit for a smooth finish.
• Consult your retailer for more information on available accessories for sanding, polishing,
stripping and scrubbing.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Attachment is not secured. • Make certain the attachment is fully
pushed into the Power Unit.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera-
tion of the Power Unit.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
B